Features:
- YLOD NEC Tokin repair PCB by RIP-Felix
- Ready to install solution for NEC Token
- ENIG 0.8mm thickness PCB
- Included 3 x 7343 tantalum pre-soldered.
- Requires advanced soldering
Description:
NOTE: Removal of NEC Token caps and repairing YLOD issues is an advanced repair, requiring detailed soldering and electronics experience, you should only attempt to use this product if you are a qualified electronics engineer or extremely competent in soldering work.
This is a populated PCB to assist in the replacement of the NEC/TOKIN bulk filter capacitors on some model PlayStation 3 consoles, PCB designed by RIP-Felix.
Each PCB combined with the three 7343 tantalum will replace one NEC Token cap.
This pcb also allows the addition of up to six 0805 Multi Layered Ceramic Capacitors (MLCC) in parallel (not included)
The addition six ceramic capacitors are optional and noted by RIP-Felix as probably being overkill, primarily this PCB is to make it easier to install 3 470uf tantalum or aluminum caps into a PS3 to replace faulty NEC Token.
2mm height capacitors or shorter must be used, this ensures it'll fit underneath the RF shield when you reassemble the console.
The 3 larger cap locations on the PCB are for 7343 (7.3 x 4.3 x 1.9mm, LxWxH), the PCB has three Panasonic 2R5TPE470M7 tantalum caps included and pre-soldered to the board.
Thanks goes to RIP-Felix for all of the research and also the design of the Tantalizer PCB.Smaller ceramic caps are not included or fitted as these are optional, if you want to fit them you will need:
Optional ceramic caps:
1x 47uF 10v X5R 0805 MLCC
1x 22uF 10v X5R 0805 MLCC
1x 10uF 10v X5R 0805 MLCC
1x 4.7uF 10v X5R 0805 MLCC
1x 2.2uF 10v X5R 0805 MLCC
1x 1uF 10v X5R 0805 MLCC
DIY part. This is a DIY part for you to fit yourself. Fitting needs care and, where stated, soldering or other technical skills – see our fitting guides. We're not responsible for damage caused by incorrect fitting, or for an existing fault in your console. Replacing a part may not fix your fault, as faults can have more than one cause. This doesn't affect your statutory rights.
Safety information:
- Not a toy. Keep out of reach of children.
- Unplug from the mains and let capacitors discharge before work.
- Small parts – choking hazard.
- Soldering required – ventilate, beware hot iron.
- Switch off, unplug and remove any batteries before fitting.
- Fit capacitors the right way round – reversed parts can burst.
- Fits listed models only – do not force.
- Fitting guides: zedlabz.com/blogs/guides
Manufacturer: Assecure Ltd (ZedLabz), The Outbuildings, Grove Farm Road, Maldon, Essex, CM9 8LR, UK · info@zedlabz.com
EU responsible person: Eucomply OÜ · Pärnu mnt 139b-14, 11317 Tallinn, Estonia · hello@eucompliancepartner.com
