Features:- Controller PCB for Game Boy LED flex boards
- Allows brightness adjustment via a pot screw
- Adds an on off function via a switch.
- Small enough to fit within the battery compartment.
- Hookup wire required to install (not included).
Description:Make adjustments to your Natalie the nerd LED mod with this small and simple control board.
The board has a Philips cross head pot screw which allows you to change the brightness of the LED flex board.
It also has a switch which allows you to turn off the LEDs if you wish to.
The board is small enough to fit neatly in the battery compartment even when batteries are installed.
Please note that the Game Boy Advance would likely require a small amount of shell trimming to accommodate the board.
Basic soldering skills are required to install this part.
Hookup wire is required to complete the installation (not included)
DIY part. This is a DIY part for you to fit yourself. Fitting needs care and, where stated, soldering or other technical skills – see our
fitting guides. We're not responsible for damage caused by incorrect fitting, or for an existing fault in your console. Replacing a part may not fix your fault, as faults can have more than one cause. This doesn't affect your statutory rights.
Safety information:
- Not a toy. Keep out of reach of children.
- Small parts – choking hazard.
- Soldering required – ventilate, beware hot iron.
- Wear eye protection when cutting or drilling.
- Switch off, unplug and remove any batteries before fitting.
- Fits listed models only – do not force.
- Fitting guides: zedlabz.com/blogs/guides
- Follow the manufacturer's instructions.
Brand / manufacturer: Natalie the Nerd · Importer / seller: Assecure Ltd (ZedLabz), The Outbuildings, Grove Farm Road, Maldon, Essex, CM9 8LR, UK · support@zedlabz.com
EU responsible person (for authorities only): FFB Estonia OÜ · Päevalille tn 6-15, Haabersti linnaosa, 13517 Tallinn, Harju maakond, Estonia · finance_estonia@fulfillment-box.com
