Features:- Overclock flex mod for Game Boy Advance
- Provides easier wire free installation
- up to 170% clock speed increase
- Compatible with IPS screen mods
- Medium difficulty level, soldering & crystal removal required.
Description:The robot_retro GBA overclocker flex mod provides a simple way of overclocking or underclocking your Gameboy advance.
The installation process has been simplified by eliminating the manual wiring process (with the exception of a single optional LED indicator wire).
NOTE: Whilst the wire free installation makes it much easier, it should be noted that the crstal will need to be removed, ideally with hot air.
Highlights:- Capable of over and underclocking to 30%, 50%, 75%, 130%, 150% or 170% of base clock.
- Increase speed = Press Start and Up
- Decease speed = Press Start and Right
- Easy flex installation with optional wire link to LED DL2A.
- Power LED will blink faster when overclocked and slower when underclocked. Base speed is a solid green LED.
- Top speed can be set to 170%, 150% or 130%
The regular install has a maximum speed of 170%. This is suitable for the stock LCD, Funnyplaying v2 or Hispeedido v2 (non-laminated) kits.
If using the Hispeedido Laminated v5, bridge solder jumper S1 to limit the speed to 150%.
If using Funnyplaying 3.0 Inch Laminated, bridge solder jumper S2 to limit the speed to 130%.
Other Features:Very low power consumption. Measured as <15mA using the Nordic Power Profiler Kit II.
Accurate base clock (4.194Mhz). Measured as >0.01% accurate.
There is will no difference between this mod and the original GBA crystal at stock speeds.
Installation:Remove the GBA crystal. Recommended to use a hot air station for this step.
Install the flex as per photos.
Solder the points shown within the pink circles (total of 6 solder points). It is recommended to use flux for this step.
OPTIONAL: Run and wire between the flex and test point DL2A (both shown inside the yellow circles). This will make the power LED blink faster/slower when over or underclocking.
Speed Limiting:- Bridge solder jumper S1 to limit the speed to 150%.
- Bridge solder jumper S2 to limit the speed to 130%.
- Developed in collaboration with RJS FPGA
DIY part. This is a DIY part for you to fit yourself. Fitting needs care and, where stated, soldering or other technical skills – see our fitting guides. We're not responsible for damage caused by incorrect fitting, or for an existing fault in your console. Replacing a part may not fix your fault, as faults can have more than one cause. This doesn't affect your statutory rights.
Safety information:
- Not a toy. Keep out of reach of children.
- Small parts – choking hazard.
- Soldering required – ventilate, beware hot iron.
- Switch off, unplug and remove any batteries before fitting.
- Fits listed models only – do not force.
- Fitting guides: zedlabz.com/blogs/guides
- Follow the manufacturer's instructions.
Brand / manufacturer: Robot Retro · Importer / seller: Assecure Ltd (ZedLabz), The Outbuildings, Grove Farm Road, Maldon, Essex, CM9 8LR, UK · info@zedlabz.com
EU responsible person: Eucomply OÜ · Pärnu mnt 139b-14, 11317 Tallinn, Estonia · hello@eucompliancepartner.com
