60mm Noctua Cooling Fan Adapter for original Xbox OG console | Retro Frog

Features:

- Mounting bracket for Xbox Noctua fan mod
- Compatible with 60mm 3 pin Noctua NF-A6x25 FLX
- Uses standard computer fan screws
- Designed by Retro Frog
- Manufactured under license in the UK

Description:

The Nexus 70mm fan works quite well in the original Xbox, however I've had folks ask me about using the Noctua 60mm fan instead.

This is primarily for 2 reasons: 1. The Noctua is slightly quieter than the Nexus. 2. Noctua fans are readily and easily available worldwide, whereas the Nexus fan are apparently difficult to source in certain parts of the world. 

This mount is split into 2 parts to allow for easier printing, use the standard Noctua include fan screws to mount each piece to the fan as shown in the photos. 

This design has the rear tabs that slide down into the case rear and indents for the tabs on each side of the original fan. This will keep the fan locked into place and not move.

Be careful when removing your original fan as to not break those tabs off. The console is 20 years old now.

Requires 60mm 3 pin Noctua NF-A6x25 FLX fan (Not included)

Install:

Fix fan to the bracket using standard computer fan screws (not included).

Licensing:

This product is produced under a commercial license agreement with a percentage of the sale going to the designer Retro Frog.

We produce this in-house using high end 3D printers and quality filament.

This is an unofficial third party product, it is not manufactured by, approved, supported or endorsed by Microsoft.