Features:- Easy install flex Amp & Macro mod for DS Lite motherboard.
- Features a 330 ohm resistor mod to convert a DS Lite to operate with only the lower screen.
- 1.5W output - Can drive a speaker of up to 2W.
- Seven solder points on ribbon mounts flex cable to the motherboard.
- Compatible with various speakers - Switch speaker recommended.
Description:Easily convert an old DS Lite console to a Game Boy Macro with this two in one flex amp lower screen enabling mod. This easy install flex requires seven solder points and will allow the DS Lite to operate from the lower screen only whilst significantly boosting the audio volume.
To install this part you should ideally use flux and a fine tip soldering iron (not included), and add solder to the mounting points on the mainboard and onto the ribbon flex pads, you can then place the flex into position and reflow the solder with your iron to secure into place.
The amp has been tested to work optimally with a Nintendo Switch speaker but is compatible with a variety of speakers.
Requires some technical fitting to install including soldering, the flex cable comes pre-populated, making installation much easier, no need to solder the tiny capacitors or other parts.
DIY part. This is a DIY part for you to fit yourself. Fitting needs care and, where stated, soldering or other technical skills – see our fitting guides. We're not responsible for damage caused by incorrect fitting, or for an existing fault in your console. Replacing a part may not fix your fault, as faults can have more than one cause. This doesn't affect your statutory rights.
Safety information:
- Not a toy. Keep out of reach of children.
- Small parts – choking hazard.
- Soldering required – ventilate, beware hot iron.
- Switch off, unplug and remove any batteries before fitting.
- Fits listed models only – do not force.
- Fitting guides: zedlabz.com/blogs/guides
- Follow the manufacturer's instructions.
Brand / manufacturer: Helder Game Tech · Importer / seller: Assecure Ltd (ZedLabz), The Outbuildings, Grove Farm Road, Maldon, Essex, CM9 8LR, UK · info@zedlabz.com
EU responsible person: Eucomply OÜ · Pärnu mnt 139b-14, 11317 Tallinn, Estonia · hello@eucompliancepartner.com
